Toolpack installation 2-5
This section covers the steps required to install the Toolpack system from a new host. You will be required to install the prerequisites listed below before installing Toolpack itself.
If you would like to migrate a Toolpack v2.2, v2.3 or 2.4 system, please follow the Toolpack Major Upgrade 2-5 procedure.
Contents |
Prerequisites
The prerequisite will be different according to your operating system. The prerequisite guide needs to be executed once per system. If your OS is not included in the list below, please contact TelcoBridges support.
The following OSes are not yet supported:
- CentOS 4 prerequisite guide
- Debian 5 prerequisite guide
- Fedora Core 8 prerequisite guide
- Solaris 10 Intel prerequisite guide
Note: For TMG3200 users, the on-board Linux host is shipped with Toolpack and its prerequisites pre-installed. For upgrades, please see Upgrading Toolpack.
Firewall settings
Make sure that your firewall enables the following services and ports.
- Service: http (SystemId/tcp) i.e.:(12358/tcp)
- Port: All ports (tcp/udp) enabled for local networks
Failure to open those ports will render socket communications between the distributed software elements unavailable.
Toolpack installation
