Web Portal:Configuration Copy

This page describes the steps required to copy a configuration within Toolpack web portal.

Note: This page assumes that you are using the Gateway application. If you are using your own application, you will be required to perform the same steps but for your plug-in.

Copy Configuration

• Go to the Configuration menu.
• Click on the Copy link of the configuration you wish to copy.
• Enter the name of your new configuration.
• Click the Copy button.
• After a copy of your configuration has been created, click on the Configure Now link of your new configuration.

Create a new Gateway/Plug in application configuration

• Go to the Gateway -> Configurations menu.
• Click on the Create New Configuration link.
• Complete the form. The Configuration should be set to the name of your new Configuration.
• Click the Create button.

Create a new Gateway/Plug in application instance

• Go to the Config -> Applications-> Instances menu.
• Click on the Create New Application Instance link.
• Complete the form. The Application Config should be set to the name of your new Gateway/Plug-in application configuration.
• Click the Create button.