Creating an MTP3 Linkset
From TBwiki
Applies to version(s): v3.0
After creating an MTP3 network, you can define linksets to logically combine multiple MTP3 links connecting to the same DPC. For example, one linkset could be the links between a point code identifying a Tmedia/Tdev SS7 node and a point code identifying the adjacent SS7 equipment.
In this use case, the previously created point code names are selected:
- destination point code: dpc333
- origination point code: opc111
To create an MTP3 linkset:
1- Click MTP3 in the navigation panel.
2- Select an MTP3 network.
3- Click Create New Mtp3 Linkset
4- Configure the new linkset:
- Enter a name for the linkset
- Select an origin point code (OPC)
- Select an adjacent point code
- Make sure the desired state is set to Active
- Click Create
5- Verify that the "Mtp3 linkset was successfully created" message appears
List of Parameters
Live states
