M2PA Status

From TBwiki
Jump to: navigation, search
Applies to version(s): v2.9, v2.10


This article illustrates how to view M2PA status and to set a periodic refresh of the M2UA protocol stack. This is done from the Status menu and the Navigation panel.

Contents

Status menu

1- Click Status in the navigation panel.

Status 0.png


2- Click the SIGTRAN M2pa tab.

TabM2PA 0.png

  • Note that SCTP is used as the Transport Layer for this protocol, if any firewall is sitting between Telcobridges device and Sigtran network, this firewall needs to be set to allow SCTP traffic to pass through, and enabling the basic connectivity for sigtran link to be up


The status of the M2UA protocol stack is displayed.

StatusM2PA 0.png

Navigation Panel

1- Click M2PA from the navigation panel.

StatusM2PA 1.png

2- Click the Status tab.

StatusM2PA 2.png

3- The status of the M2PA SAPs is shown.

  • To configure a periodic refresh of the M2PA status, select a value from Refresh Every.
  • Select Links to view Saps and Links status.

StatusM2PA 3.png

4- The M2PA SAPS links are shown.

  • Select any SAP link to view further status.

StatusM2PA 4.png

5-To view the SAP links, click the Links tab.

StatusM2PA 5.png

Path

/configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2pa_stacks/@[m2pa_name]/status
Personal tools