|
|
| Line 51: |
Line 51: |
| | *[[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure SIGTRAN]] | | *[[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure SIGTRAN]] |
| | | | | | |
| − | *[[Configure H.248]]
| + | When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], make the following specific settings: |
| | + | * Local IP Address and Public IP Address: x.x.x.x [Public IP orNAT public IP] |
| | + | |
| | | | | | |
| | *[[Configure RADIUS]] | | *[[Configure RADIUS]] |
Revision as of 15:01, 23 April 2015
Applies to version(s): v2.8.
This article provides the steps required to complete the most common IP network configurations using the Web Portal.
One subnet, Two IP Addresses, Untagged
Note:
A TMG3200 in a tagged configuration can use eth0 and eth1.
VoipO/Voip1 bonding is optional.
| Configure IP Network A
|
Configure IP Network B
|
|
Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port.
|
Subnet B is untagged and bonded over VOIP0 and VOIP1 ports.
When you Create an IP Virtual Port, configure it as follows:
- Name: vp VOIP U
- vLanId: Untagged
- Physical Ports: voip0, voip1
When you Create an IP Address, configure it as follows:
- Name: VOIP_UNTAG
- Virtual Ports: vp VOIP U
- IP Address: x.x.x.y
- Services: RTP, SIP, SIGTRAN
|
| Configure SIP
|
Configure SIGTRAN
|
Configure H.248
|
Configure RADIUS
|
|
|
|
When you Configure H.248, make the following specific settings:
- Local IP Address and Public IP Address: x.x.x.x [Public IP orNAT public IP]
|
|
|
Two subnets, One IP per subnet, untagged
[image of network configuration 2]
| Configure IP Network A
|
Configure IP Network B
|
|
Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port.
|
Subnet B is untagged and is bonded over VOIP0 and VOIP1 ports.
|
| Configure SIP
|
Configure SIGTRAN
|
Configure H.248
|
Configure RADIUS
|
|
|
|
|
|
|
Two VLAN, Three IP Address, tagged
[image of network configuration 3]
| Configure IP Network A
|
Configure IP Network B
|
|
|
Subnet B uses untag bonded over VOIP0 and VOIP1 ports
|
| Configure SIP
|
Configure SIGTRAN
|
Configure H.248
|
Configure RADIUS
|
|
|
|
|
|
|
