Use Cases:Network Configuration A
From TBwiki
(Difference between revisions)
(Add number's referring to the example above) |
(Added IP addresses for H248 and Virtual IP Port) |
||
| Line 19: | Line 19: | ||
|- | |- | ||
| | | | ||
| − | Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port. | + | Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port. Configure the parameters as follows: |
| − | + | *'''IP Address''': 192.168.4.10 | |
| − | *IP Address: 192.168.4.10 | + | *'''Netmask''': 255.255.255.0 |
| − | *Netmask: 255.255.255.0 | + | *'''Default gateway''': 192.168.4.1 |
| − | *Default gateway: 192.168.4.1 | + | |
| Line 40: | Line 39: | ||
**'''Name''': VOIP_UNTAG | **'''Name''': VOIP_UNTAG | ||
**'''Virtual Ports''': vp VOIP U | **'''Virtual Ports''': vp VOIP U | ||
| − | **'''IP Address''': | + | **'''IP Address''': 192.168.4.20 |
| + | **'''Netmask''': 255.255.255.0 | ||
**'''Services''': RTP, SIP, SIGTRAN | **'''Services''': RTP, SIP, SIGTRAN | ||
| Line 57: | Line 57: | ||
| | | | ||
*When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], set the following: | *When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], set the following: | ||
| − | **'''Local IP Address and Public IP Address''': | + | **'''Local IP Address and Public IP Address''': 192.168.4.210 [Public IP orNAT public IP] |
| | | | ||
Revision as of 09:53, 24 April 2015
Applies to version(s): v2.8.
Contents |
This article provides the steps required to complete the most common IP network configurations using the Web Portal.
One subnet, Two IP Addresses, Untagged
Note: VoipO/Voip1 bonding is optional.
|
Two subnets, One IP per subnet, untagged
[image of network configuration 2]
|
Two VLAN, Three IP Address, tagged
[image of network configuration 3]
|
