FreeSBC:SIP Trunking FreeSWITCH:Example A
From TBwiki
(Difference between revisions)
(→NAP Configuration) |
(→NAP Configuration) |
||
Line 43: | Line 43: | ||
** Here, You must create two NAPs, one SIP NAP will be FreeSWITCH NAP and other NAP will be for SIP trunk provided by ITSP | ** Here, You must create two NAPs, one SIP NAP will be FreeSWITCH NAP and other NAP will be for SIP trunk provided by ITSP | ||
+ | '''Optional''' | ||
*[[Configuring SIP Registration to SIP Proxy|SIP Trunk with Registration]] | *[[Configuring SIP Registration to SIP Proxy|SIP Trunk with Registration]] |
Revision as of 02:40, 15 April 2020
Contents |
Applies to version: v3.1
Introduction
SIP Trunk Configuration Instruction with FreeSWITCH Example Configuration provides you with a step by step SIP Trunk Configuration of ProSBC with FreeSWITCH systems, using the Web Portal configuration tool. Complete general installation configuration steps, before you begin configuring your specific scenario. In this guide FQDN (freeswitch.telcobridges.com) configured in the FreeSWITCH server. If you don't use FQDN, you can use FreeSWITCH IP address too. Please check how to configure the SIP Trunk in FreeSWITCH for ProSBC from FreeSWITCH Trunk Creation
FreeSWITCH SIP Trunk Example
Configuration Steps
(Step 1) Create IP Network |
(Step 2) Create Protocol Stack |
(Step 3) Create Call Route |
---|---|---|
|
NAP Configuration
- See Create SIP NAP
- Here, You must create two NAPs, one SIP NAP will be FreeSWITCH NAP and other NAP will be for SIP trunk provided by ITSP
Optional