Toolpack:Creating an MTP3 Configuration B
From TBwiki
(Difference between revisions)
(→List of Parameters) |
(→List of Parameters) |
||
| Line 29: | Line 29: | ||
* [[Parameter: Enabled|Enabled]] | * [[Parameter: Enabled|Enabled]] | ||
* [[Parameter: SSf Validation|SSf Validation]] | * [[Parameter: SSf Validation|SSf Validation]] | ||
| − | * [[Parameter: | + | * [[Parameter: Signaling Point Type|Signaling Point Type]] |
| − | * [[Parameter: | + | * [[Parameter: MTP3 T15 Timer|T15 Timer]] |
| − | * [[Parameter: | + | * [[Parameter: MTP3 T16 Timer|T16 Timer]] |
| − | * [[Parameter: | + | * [[Parameter: MTP3 T18 Timer|T18 Timer]] |
| − | * [[Parameter: | + | * [[Parameter: MTP3 T19 Timer|T19 Timer]] |
| − | * [[Parameter: | + | * [[Parameter: MTP3 T21 Timer|T21 Timer]] |
| − | * [[Parameter: | + | * [[Parameter: MTP3 T26 Timer|T26 Timer]] |
| − | + | ||
| − | + | ||
| + | Advanced Parameters | ||
| + | * [[Parameter: MTP3 Ssf Validation|Ssf Validation]] | ||
* [[Parameter: Restart Procedure|Restart Procedure]] | * [[Parameter: Restart Procedure|Restart Procedure]] | ||
| + | * [[Parameter: MTP3 Transfer Restricted required|Transfer Restricted required]] | ||
Latest revision as of 13:55, 17 December 2012
Applies to version(s): v2.6
Now that you have set up the MTP2 layer of your SS7 system, you must create an MTP3 configuration. MTP3 provides message routing between signaling points in an SS7 network.
To create an MTP3 configuration:
1- Select MTP3 from the navigation panel
2- Configure the new MTP3 service:
- Enter a name for the MTP3 configuration
- Make sure the Enabled and SSf Validation boxes are checked
- Select SP as the signaling point type
- Select a restart procedure
- Click Create
3- Verify that the "Mtp3Cfg was successfully created" message appears
List of Parameters
- Name
- Enabled
- SSf Validation
- Signaling Point Type
- T15 Timer
- T16 Timer
- T18 Timer
- T19 Timer
- T21 Timer
- T26 Timer
Advanced Parameters
