Creating an MTP3 Configuration

Applies to version(s): v2.6

Now that you have set up the MTP2 layer of your SS7 system, you must create an MTP3 configuration. MTP3 provides message routing between signaling points in an SS7 network.

To create an MTP3 configuration:

1- Select MTP3 from the navigation panel

2- Configure the new MTP3 service:

• Enter a name for the MTP3 configuration
• Make sure the Enabled and SSf Validation boxes are checked
• Select SP as the signaling point type
• Select a restart procedure
• Click Create

3- Verify that the "Mtp3Cfg was successfully created" message appears

List of Parameters

• Name
• Enabled
• SSf Validation
• Signaling Point Type
• T15 Timer
• T16 Timer
• T18 Timer
• T19 Timer
• T21 Timer
• T26 Timer

Advanced Parameters

• Ssf Validation
• Restart Procedure
• Transfer Restricted required