ProSBC:Cisco SIP Trunk:Configuration A
From TBwiki
(Difference between revisions)
(→NAP Configuration) |
|||
| Line 41: | Line 41: | ||
* See [[Toolpack:Allocating a SIP Network Access Point (NAP) SBC A|Create SIP NAP]] | * See [[Toolpack:Allocating a SIP Network Access Point (NAP) SBC A|Create SIP NAP]] | ||
| − | ** Here, You must create two NAPs, one SIP NAP will be | + | ** Here, You must create two NAPs, one SIP NAP will be Cisco UCM NAP and the other NAP will be for the SIP trunk provided by ITSP |
Latest revision as of 08:21, 11 March 2021
Contents |
Applies to version: v3.1
Introduction
SIP Trunk Configuration Instruction with Cisco Unified Communications Manager Example Configuration provides you with a step-by-step SIP Trunk Configuration of ProSBC with Cisco UCM 12 systems, using the Web Portal configuration tool. Complete general installation configuration steps, before you begin configuring your specific scenario. Please check how to configure the SIP Trunk in Cisco UCM for ProSBC from Adding ProSBC as a SIP Trunk in Cisco UCM
Cisco UCM SIP Trunk Example
Configuration Steps
| (Step 1) Create IP Network |
(Step 2) Create Protocol Stack |
(Step 3) Create Call Route |
|---|---|---|
|
NAP Configuration
- See Create SIP NAP
- Here, You must create two NAPs, one SIP NAP will be Cisco UCM NAP and the other NAP will be for the SIP trunk provided by ITSP
