Toolpack:Creating an MTP3 Route A

From TBwiki

(Difference between revisions)

Latest revision as of 13:47, 12 February 2014

MTP3 routes are built to route traffic from previously created point codes using linksets.

You require 1 route per point codes in your system. This means 1 route per DPC (SSP and STP) and 1 per source point code (OPC).

To create an MTP3 route:

1- Click Create New Mtp3 Route in the MTP3 network configuration window:

2- Configure the new MTP3 route:

Enter a name for the route
Select a point code for the route
Select a restart procedure
Select a point type
Check the Route to Adjacent box, if this route is directed to an adjacent network
Click Create

3- Verify that the "Mtp3Route was successfully created" message appears

4- Associate the newly created route with a linkset:

Select a linkset from the list provided at the bottom of the route configuration window
Click the "<<" button to associate the linkset with the newly created route

@@ Line 1: / Line 1: @@
-[[MTP3 Layer|MTP3]] routes are built to route traffic from previously created point codes using linksets. One route is created for each previously defined point code.
+=== '''''Applies to version(s): v2.5, v2.6., 2.7''''' ===
+{{DISPLAYTITLE:Creating an MTP3 Route}}
+[[MTP3 Layer|MTP3]] routes are built to route traffic from previously created point codes using linksets.
+You require 1 route per point codes in your system. This means 1 route per DPC (SSP and STP) and 1 per source point code (OPC).
 To create an MTP3 route:
@@ Line 36: / Line 40: @@
 * [[Parameter: Point Code|Point Code]]
 * [[Parameter: Restart Procedure|Restart Procedure]]
-* [[Parameter: Point Type|Point Type]]
+* [[Parameter: Signaling Point Type|Point Type]]
 * [[Parameter: Route to Adjacent|Route to Adjacent]]