Use Cases:Network Configuration A
(→One subnet, Two IP Addresses, Untagged) |
(→One subnet, Two IP Addresses, Untagged) |
||
Line 8: | Line 8: | ||
[[Image:UseCase_OneSubTwoIpUntagged_0.png]] | [[Image:UseCase_OneSubTwoIpUntagged_0.png]] | ||
+ | |||
+ | Note: | ||
+ | A TMG3200 in a tagged configuration can use eth0 and eth1. | ||
+ | VoipO/Voip1 bonding is optional. | ||
{| | {| |
Revision as of 14:48, 23 April 2015
Applies to version(s): v2.8.
Contents |
This article provides the steps required to complete the most common IP network configurations using the Web Portal.
One subnet, Two IP Addresses, Untagged
Note: A TMG3200 in a tagged configuration can use eth0 and eth1. VoipO/Voip1 bonding is optional.
|
Two subnets, One IP per subnet, untagged
[image of network configuration 2]
|
Two VLAN, Three IP Address, tagged
[image of network configuration 3]
|