Use Cases:Network Configuration A
From TBwiki
(Difference between revisions)
(→One subnet, Two IP Addresses, Untagged) |
(→One subnet, Two IP Addresses, Untagged) |
||
| Line 33: | Line 33: | ||
*When you [[Toolpack:Configuring_VoIP_Interfaces C|Create an IP Address]], configure it as follows: | *When you [[Toolpack:Configuring_VoIP_Interfaces C|Create an IP Address]], configure it as follows: | ||
| − | **Name: VOIP_UNTAG | + | **'''Name''': VOIP_UNTAG |
| − | **Virtual Ports: vp VOIP U | + | **'''Virtual Ports''': vp VOIP U |
| − | **IP Address: x.x.x.y | + | **'''IP Address''': x.x.x.y |
| − | **Services: RTP, SIP, SIGTRAN | + | **'''Services''': RTP, SIP, SIGTRAN |
|- | |- | ||
| Line 52: | Line 52: | ||
| | | | ||
*When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], set the following: | *When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], set the following: | ||
| − | **Local IP Address and Public IP Address: x.x.x.x [Public IP orNAT public IP] | + | **'''Local IP Address and Public IP Address''': x.x.x.x [Public IP orNAT public IP] |
| | | | ||
*When you [[Toolpack:CDR_Settings_A|Configure RADIUS]], set the following: | *When you [[Toolpack:CDR_Settings_A|Configure RADIUS]], set the following: | ||
| − | **Source IP interface: Any | + | **'''Source IP interface''': Any |
| − | **Radius -> Radius Server | + | **'''Radius -> Radius Server''' |
| − | **Public IP Address: Empty | + | **'''Public IP Address''': Empty |
|} | |} | ||
|} | |} | ||
Revision as of 15:09, 23 April 2015
Applies to version(s): v2.8.
Contents |
This article provides the steps required to complete the most common IP network configurations using the Web Portal.
One subnet, Two IP Addresses, Untagged
Note: A TMG3200 in a tagged configuration can use eth0 and eth1. VoipO/Voip1 bonding is optional.
|
Two subnets, One IP per subnet, untagged
[image of network configuration 2]
|
Two VLAN, Three IP Address, tagged
[image of network configuration 3]
|
