Use Cases:Network Configuration A

From TBwiki
(Difference between revisions)
Jump to: navigation, search
(→One subnet, Two IP Addresses, Untagged)
(→One subnet, Two IP Addresses, Untagged)
Line 55: Line 55:
 
|  
 
|  
 
*When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], set the following:
 
*When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], set the following:
−
**'''Local IP Address and Public IP Address''': 192.168.4.210 [Public IP orNAT public IP]
+
**'''Local IP Address and Public IP Address''': 192.168.4.210
 +
[Public IP or NAT public IP]
  
 
|  
 
|  

Revision as of 10:11, 24 April 2015

Applies to version(s): v2.8.

Contents


This article provides the steps required to complete the most common IP network configurations using the Web Portal.

One subnet, Two IP Addresses, Untagged

Use Case: Configuraring an IP network one subnet, two IP addresses, untagged.


Configure IP Network A Configure IP Network B

Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port. Configure the parameters as follows:

  • IP Address: 192.168.4.10
  • Netmask: 255.255.255.0
  • Default gateway: 192.168.4.1


Subnet B is untagged and bonded over VOIP0 and VOIP1 ports.



  • When you Create an IP Address, configure it as follows:
    • Name: VOIP_UNTAG
    • Virtual Ports: vp VOIP U
    • IP Address: 192.168.4.20
    • Netmask: 255.255.255.0
    • Services: RTP, SIP, SIGTRAN
Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS
  • When you Configure H.248, set the following:
    • Local IP Address and Public IP Address: 192.168.4.210

[Public IP or NAT public IP]

  • When you Configure RADIUS, set the following:
    • Source IP interface: Any
    • Radius -> Radius Server
    • Public IP Address: Empty

Two subnets, One IP per subnet, untagged

[image of network configuration 2]

Configure IP Network A Configure IP Network B

Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port.

Subnet B is untagged and is bonded over VOIP0 and VOIP1 ports.

Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS

Two VLAN, Three IP Address, tagged

[image of network configuration 3]

Configure IP Network A Configure IP Network B

Subnet B uses untag bonded over VOIP0 and VOIP1 ports

Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS
Retrieved from "https://docs.telcobridges.com/mediawiki/index.php?title=Use_Cases:Network_Configuration_A&oldid=18229"
Personal tools