Replace TMG3200 1+1 Primary With Spare
From TBwiki
(Difference between revisions)
(New page for 1+1 primary unit replacement) |
(Small changes) |
||
| Line 7: | Line 7: | ||
== Removing the Defective Unit == | == Removing the Defective Unit == | ||
*Shutdown the Primary TMG3200 | *Shutdown the Primary TMG3200 | ||
| − | *Disconnect from the | + | *Disconnect from the 1+1 patch panel |
*Disconnect from the VoIP network | *Disconnect from the VoIP network | ||
*Disconnect from the Management network | *Disconnect from the Management network | ||
| Line 17: | Line 17: | ||
*Connect to the Management Interface | *Connect to the Management Interface | ||
*Connect to the VoIP Network | *Connect to the VoIP Network | ||
| − | *Connect to the | + | *Connect to the 1+1 patch panel |
*Connect the ETH0 and ETH1 port to the secondary unit | *Connect the ETH0 and ETH1 port to the secondary unit | ||
== Starting Up the TMG3200 == | == Starting Up the TMG3200 == | ||
| − | *Power up the TMG3200 | + | *Power up the spare TMG3200 |
*[[TMG:Change_Management_IP_Address|Configure the Management IP address]] | *[[TMG:Change_Management_IP_Address|Configure the Management IP address]] | ||
*Connect to the web portal: '''http://[IP address]:12358''' | *Connect to the web portal: '''http://[IP address]:12358''' | ||
| Line 31: | Line 31: | ||
**[[Toolpack:Uploading_a_License_A|Install License Procedure for v2.7]] | **[[Toolpack:Uploading_a_License_A|Install License Procedure for v2.7]] | ||
*Upgrade (or downgrade) this unit to the same version as the defective unit: [[Gateway_Upgrade|Software upgrade]] | *Upgrade (or downgrade) this unit to the same version as the defective unit: [[Gateway_Upgrade|Software upgrade]] | ||
| − | |||
== Configuring the replacement unit == | == Configuring the replacement unit == | ||
Revision as of 15:45, 18 April 2016
This procedure does not require system downtime.
Start with the following steps: Prepare for replacement
The replacement of a Primary TMG3200 is comprised of following steps:
Contents |
Removing the Defective Unit
- Shutdown the Primary TMG3200
- Disconnect from the 1+1 patch panel
- Disconnect from the VoIP network
- Disconnect from the Management network
- Remove the Primary TMG3200 from the equipment rack
Installing the Replacement Unit
Refer to TMG3200 Installation guide
- Rack-mount the Replacement Unit
- Connect to the Management Interface
- Connect to the VoIP Network
- Connect to the 1+1 patch panel
- Connect the ETH0 and ETH1 port to the secondary unit
Starting Up the TMG3200
- Power up the spare TMG3200
- Configure the Management IP address
- Connect to the web portal: http://[IP address]:12358
- Configure the unit in standalone mode (to set the appropriate version on the unit)
- Install the license of the replacement unit
- Upgrade (or downgrade) this unit to the same version as the defective unit: Software upgrade
Configuring the replacement unit
- Once the same version as the secondary unit is installed on this unit, Reset the host role:
- and configure it as primary:
- Set primary host role - NOTE: When you are asked if the unit should get configuration and packages from an existing secondary unit, select YES and click Continue.
The configuration database will replicate itself from the secondary unit and will be ready to process calls a few minutes later.
