Monitoring patch panel
From TBwiki
(Difference between revisions)
(added data sheet and category) |
|||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
| − | |||
The TelcoBridges Monitoring Patch Panel, used in conjunction with the TM1000TM Network Probe, enables the monitoring of up to 32 E1/T1/J1 signals. | The TelcoBridges Monitoring Patch Panel, used in conjunction with the TM1000TM Network Probe, enables the monitoring of up to 32 E1/T1/J1 signals. | ||
| Line 10: | Line 6: | ||
| + | == References == | ||
| + | *[[media:Monitoring patch panel datasheet.pdf| Data sheet]] | ||
| − | |||
| − | + | [[category:Hardware]] | |
Revision as of 15:24, 20 July 2009
The TelcoBridges Monitoring Patch Panel, used in conjunction with the TM1000TM Network Probe, enables the monitoring of up to 32 E1/T1/J1 signals.
The patch panel connects to the tapped E1/T1/J1 signals to be monitored. It can be equipped with high-impedance circuits to limit the current drain on the active E1/T1/J1 signal such that it can probe the electrical signal while minimizing disturbances on the actual signal itself.
The connected signals are routed to the TM1000 Network Probe which receives them to detect and capture SS7 messages, HDLC-like packets, record PCM voice, or the raw bit stream.
