Toolpack v2.4:Edit the M2PA Configuration
From TBwiki
(Difference between revisions)
(Created page with '==To create an M2PA configuration:== '''1. Select "M2PA" from the navigation panel:''' Image:Web_Portal_v2.4_Navigation_Panel_M2PA.png '''2. Configure the new M2PA service…') |
|||
| Line 1: | Line 1: | ||
| + | [[M2PA]] replaces the MTP2 layer entirely; however, it still requires the MTP3 layer. | ||
| + | |||
==To create an M2PA configuration:== | ==To create an M2PA configuration:== | ||
Revision as of 11:43, 26 December 2009
M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.
To create an M2PA configuration:
1. Select "M2PA" from the navigation panel:
2. Configure the new M2PA service:
- Enter a name for the M2PA configuration
- Change the "Timers" setting, if necessary
- Click "Create" to finalise the configuration
3. Verify that the "M2pa Cfg was successfully created" message appears:
