Toolpack:Creating an MTP3 Route A
From TBwiki
(Difference between revisions)
| Line 14: | Line 14: | ||
* Select a '''restart procedure''' | * Select a '''restart procedure''' | ||
* Select a '''point type''' | * Select a '''point type''' | ||
| − | * Check the '''Route to Adjacent''' box, if this route is directed an | + | * Check the '''Route to Adjacent''' box, if this route is directed to an adjacent network |
* Click '''Create''' | * Click '''Create''' | ||
| Line 29: | Line 29: | ||
[[Image:Toolpack_v2.5_MTP3_Route_Linkset.png]] | [[Image:Toolpack_v2.5_MTP3_Route_Linkset.png]] | ||
| + | |||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Point Code|Point Code]] | ||
| + | * [[Parameter: Restart Procedure|Restart Procedure]] | ||
| + | * [[Parameter: Point Type|Point Type]] | ||
| + | * [[Parameter: Route to Adjacent|Route to Adjacent]] | ||
Revision as of 14:11, 4 August 2010
MTP3 routes are built to route traffic from previously created point codes using linksets. One route is created for each previously defined point code.
To create an MTP3 route:
1- Click Create New Mtp3 Route in the MTP3 network configuration window:
2- Configure the new MTP3 route:
- Enter a name for the route
- Select a point code for the route
- Select a restart procedure
- Select a point type
- Check the Route to Adjacent box, if this route is directed to an adjacent network
- Click Create
3- Verify that the "Mtp3Route was successfully created" message appears
4- Associate the newly created route with a linkset:
- Select a linkset from the list provided at the bottom of the route configuration window
- Click the "<<" button to associate the linkset with the newly created route
