Use Cases:Network Configuration A
From TBwiki
(Difference between revisions)
(→One subnet, Two IP Addresses, Untagged) |
(→One subnet, Two IP Addresses, Untagged) |
||
| Line 26: | Line 26: | ||
| − | When you [[Toolpack:Configuring_Virtual_Port A|Create an IP Virtual Port]], configure it as follows: | + | *When you [[Toolpack:Configuring_Virtual_Port A|Create an IP Virtual Port]], configure it as follows: |
| − | *Name: vp VOIP U | + | **Name: vp VOIP U |
| − | *vLanId: Untagged | + | **vLanId: Untagged |
| − | *Physical Ports: voip0, voip1 | + | **Physical Ports: voip0, voip1 |
| − | When you [[Toolpack:Configuring_VoIP_Interfaces C|Create an IP Address]], configure it as follows: | + | *When you [[Toolpack:Configuring_VoIP_Interfaces C|Create an IP Address]], configure it as follows: |
| − | *Name: VOIP_UNTAG | + | **Name: VOIP_UNTAG |
| − | *Virtual Ports: vp VOIP U | + | **Virtual Ports: vp VOIP U |
| − | *IP Address: x.x.x.y | + | **IP Address: x.x.x.y |
| − | *Services: RTP, SIP, SIGTRAN | + | **Services: RTP, SIP, SIGTRAN |
|- | |- | ||
| Line 51: | Line 51: | ||
*[[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure SIGTRAN]] | *[[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure SIGTRAN]] | ||
| | | | ||
| − | When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], | + | *When you [[Toolpack:Protocol_Stack_Settings_A#H.248 MEGACO|Configure H.248]], set the following: |
| − | * Local IP Address and Public IP Address: x.x.x.x [Public IP orNAT public IP] | + | **Local IP Address and Public IP Address: x.x.x.x [Public IP orNAT public IP] |
| | | | ||
| − | *[[Configure RADIUS]] | + | *When you [[Toolpack:CDR_Settings_A|Configure RADIUS]], set the following: |
| + | **Source IP interface: Any | ||
| + | **Radius -> Radius Server | ||
| + | **Public IP Address: Empty | ||
|} | |} | ||
|} | |} | ||
Revision as of 15:06, 23 April 2015
Applies to version(s): v2.8.
Contents |
This article provides the steps required to complete the most common IP network configurations using the Web Portal.
One subnet, Two IP Addresses, Untagged
Note: A TMG3200 in a tagged configuration can use eth0 and eth1. VoipO/Voip1 bonding is optional.
|
Two subnets, One IP per subnet, untagged
[image of network configuration 2]
|
Two VLAN, Three IP Address, tagged
[image of network configuration 3]
|
