Toolpack:Creating an M2PA SAP D

Allyntree (Talk | contribs)
(Created page with "=== '''''Applies to version(s): v2.9.''''' === {{DISPLAYTITLE:Creating an M2PA SAP}} After you create an M2PA configuration, you must create a new M2PA service access point (S...")
Newer edit →

---

Revision as of 09:46, 1 December 2015

Applies to version(s): v2.9.

After you create an M2PA configuration, you must create a new M2PA service access point (SAP), which functions as the identifying label for endpoints in your network.

To create a new M2PA SAP:

1- Select M2PA from the navigation panel

2- Click Create new M2PA Sap

3- Configure the new M2PA SAP:

• Enter a name for the SAP
• Enter an SCTP source port for the SAP
• Click Create

4- Verify that the "M2pa Sap was successfully created" message appears

5- Associate IP interfaces

• Select an IP interface from the list in the information panel
• Click the "<<" button to add the selected IP interface. This is the outgoing route from the hardware adapter.

Before

After

Path

Parameters (text)

Parameters (json)

List of Parameters

• Name
• SCTP Source Port