Toolpack:Creating the M2UA Configuration D

Allyntree (Talk | contribs)
(Created page with "=== '''''Applies to version(s): v2.9.''''' === {{DISPLAYTITLE:Creating the M2UA Configuration}} To create your M2UA system, you must create a new M2UA configuration. M2UA...")
Newer edit →

---

Revision as of 09:57, 3 December 2015

Applies to version(s): v2.9.

To create your M2UA system, you must create a new M2UA configuration.

M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the MTP2 Layer of a signaling gateway to the MTP3 Layer of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.

To create an M2UA configuration:

1- Click M2UA in the navigation panel

2- Create the M2UA configuration:

• Enter a name for the M2UA service
• Select a Node Type (SG, ASP, M2UA-MTP2 Relay)
• Click Create

3- Verify that the "M2ua Cfg was successfully created" message appears

Path

Parameters (text)

Parameters (json)

List of Parameters

• Name
• M2UA Node Type