From TBwiki
(Difference between revisions)
|
|
| Line 8: |
Line 8: |
| | |- | | |- |
| | |Tmedia | | |Tmedia |
| − | |2.8 | + | |2.8, 2.9, 2.10, 3.0, 3.2 |
| | |} | | |} |
| | | | |
Latest revision as of 14:38, 10 December 2020
| This article applies to:
|
Product
|
Version
|
| Tmedia
|
2.8, 2.9, 2.10, 3.0, 3.2
|
One IP Addresses except for management, all tagged traffic, local only (TMG800 only)
| Configure IP Network
|
|
Configure IP Address & Virtual Port.
- Virtual Port Configuration:
- 1. Name: GW_Internal:
- VLan ID: 3999 Physical
- Port: Voip0, Voip1
- Note: It is recommended to use vLan ID 3999 for the internal network (not required on the external switches).
- 2. Name: Public_IP_VLan250:
- VLan ID: 250
- Physical Port: Voip0, Voip1
- Note: This is the external network vLan that must be configured on the external switch.
- IP Interface Configuration:
- 1. Name: Radius Internal
- Virtual Port: GW_Internal
- IP Address: 192.168.217.2
- Subnet mask: 255.255.255.0
- Gateway: 192.168.217.2
- Service: H.248 / Radius
- 2. Name: Voip_Internal
- Virtual Port: GW_Internal
- IP Address: 192.168.217.3
- Subnet mask: 255.255.255.0
- Gateway: 192.168.217.2
- Service: RTP, SIP, Sigtran.
- 3. Name: All_Public_250
- Virtual Port: Public_IP_VLan250
- IP Address: X.X.X.X (Public IP Address)
- Subnet mask: X.X.X.X
- Gateway: X.X.X.X
- Service: H.248 / Radius.
|
| Configure NAT
|
- NAT Configuration:
- Advanced Networking -> NATs -> Create New Internal NAT
- Name: Internal NAT
- Local Gateway IP Interface:[Unit]:GW_INTERNAL
- Public Interface: [Unit]:ALL_PUBLIC_250
- Advanced Networking -> NATs -> Create New NAT Traversal
- Name: PUBLIC_IP
- Method:Force Public IP
- Public IP Address: X.X.X.X [Public IP]
- Create NAT Traversal
- Create Internal NAT
|
| Configure SIP
|
Configure SIGTRAN
|
Configure H.248
|
Configure RADIUS
|
- Configure SIP
- IP range parameters:
- Name: PORT_RANGE_VOIP
- IP Interface: VOIP_ADDRESS
- Minimum Port: 20000
- Maximum Port: 30000
- SIP transport server parameters:
- Port: 5060
- IP Interface: VOIP_ADDRESS
- SIP NAP parameters:
- Proxy Address: X.X.X.X
- Port Range: PORT_RANGE_VOIP
|
|
- When you Configure H.248, set the following:
- Local IP Address and Public IP Address: X.X.X.X
[Public IP or NAT public IP]
|
- When you Configure RADIUS, set the following:
- Source IP interface: RADIUS_100
- Radius -> Radius Server
- Public IP Address: Empty
|
|
