Toolpack v2.3:Configuring E1/T1/J1 Line Services
From TBwiki
(Difference between revisions)
(→To configure a line service) |
(→To create a line service) |
||
| Line 8: | Line 8: | ||
[[Image:Navigation_Panel_v2.3_Line_Interfaces.png]] | [[Image:Navigation_Panel_v2.3_Line_Interfaces.png]] | ||
| + | '''2. Click 'Edit' next to the line service''' | ||
| − | ''' | + | |
| + | [[Image:Web_Portal_v2.3_Edit_Line_Interface.png|700px]] | ||
| + | |||
| + | '''3. Click 'New Child Line Service' from the Line Interface Information panel.''' | ||
| Line 15: | Line 19: | ||
| − | ''' | + | '''4. Enter a name for the line service and click 'Create'.''' |
| Line 21: | Line 25: | ||
| − | ''' | + | '''5. The resulting line service is displayed in the information panel.''' |
| Line 27: | Line 31: | ||
| − | ''' | + | '''6. Repeat this procedure for each T1/E1/J1 line that you will use.''' |
== Verifying Status == | == Verifying Status == | ||
To verify the status of a line service, either select Status from the Navigation panel or select the Status | To verify the status of a line service, either select Status from the Navigation panel or select the Status | ||
tab in the Information panel. | tab in the Information panel. | ||
Revision as of 11:55, 25 October 2009
Line services correspond to the payload content of physical lines, therefore in order to configure a Line Service for a line interface, the line interfaces should already have been configured.
To create a line service
1. Select Line Interfaces from the navigation panel.
2. Click 'Edit' next to the line service
3. Click 'New Child Line Service' from the Line Interface Information panel.
4. Enter a name for the line service and click 'Create'.
5. The resulting line service is displayed in the information panel.
6. Repeat this procedure for each T1/E1/J1 line that you will use.
Verifying Status
To verify the status of a line service, either select Status from the Navigation panel or select the Status tab in the Information panel.
