Toolpack v2.3:Adding a DS3 Line Interface

Allyntree (Talk | contribs)
(Created page with 'Note: In order to add a line interface, the Tmedia unit must have a TDM module installed. == To add a line interface == '''1. Select Line Interfaces from the navigation panel.'…')
Newer edit →

---

Revision as of 13:06, 25 October 2009

Note: In order to add a line interface, the Tmedia unit must have a TDM module installed.

To add a line interface

1. Select Line Interfaces from the navigation panel.

2. Click 'Create New Line Interface' from the Information panel.

3. To create a DS3 line interface:

• Enter a name for the line interface, and set the Line Type to DS3

• Local indexes are zero-based values. Local index 0 corresponds to DS3 trunk 1 and local index 2 corresponds to DS3 trunk 3. Enter a unique local index number for each DS3 line interface (0-2).

• Set the Line Length, Encoding, and Signal Level.

• Click Create.

The 'Line interface was successfully created' message is displayed.