Use Cases:Network Configuration

Applies to version(s): v2.8.

This article provides the steps required to complete the most common IP network configurations using the Web Portal.

One subnet, Two IP Addresses, Untagged

Configure IP Network A Configure IP Network B Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port. tbchangeip Subnet B is untagged and bonded over VOIP0 and VOIP1 ports. When you are *creating an IP virtual port, configure it as follows: Name: vp VOIP U vLanId: Untagged Physical Ports: voip0, voip1 Create Virtual Port Create IP Address Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS

Two subnets, One IP per subnet, untagged

[image of network configuration 2]

Configure IP Network A Configure IP Network B Subnet A uses the MGMT0 network interface; because it is untagged its IP can only be configured with the tbchangeip command on the SSH port. tbchangeip Subnet B is untagged and is bonded over VOIP0 and VOIP1 ports. Create Virtual Port Create IP Address Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS

Two VLAN, Three IP Address, tagged

[image of network configuration 3]

Configure IP Network A Configure IP Network B Create Virtual Port Create IP Address Subnet B uses untag bonded over VOIP0 and VOIP1 ports Create Virtual Port Create IP Address Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS Configure SIP Configure SIGTRAN Configure H.248 Configure RADIUS