Replace TMG3200 Standalone With Spare
From TBwiki
Revision as of 14:17, 11 December 2018 by Luc Morissette (Talk | contribs)
Warning: This procedure will require some system downtime.
Start with the following steps: Prepare for replacement
The replacement of a standalone TMG3200 is comprised of following steps:
Contents |
Removing the Defective Unit
- Shutdown the TMG3200
- Disconnect from the PSTN network
- Disconnect from the VoIP network
- Disconnect from the Management network
- Remove the TMG3200 from the equipment rack
Installing the Replacement Unit
Refer to TMG3200 Installation guide
- Rack-mount the Replacement Unit
- Connect to the Management Interface
- Connect to the VoIP Network
- Connect to the PSTN Network
Starting Up the TMG3200
- Power up the TMG3200
- Configure the Management IP address
- Connect to the web portal: http://[IP address]:12358
- Install the license of the replacement unit
- Upgrade this unit to the same version as the defective unit: Software upgrade
Restoring the configuration to the replacement unit
If a database backup is available,import database using the Web Portal Backup menu:
Configuring the replacement unit
If a database backup is not available, configure the system via the web portal:
