FreeSBC Configuration Files for Remote Office/Workers Scenario

Introduction

FreeSBC Configuration Files for Remote Office/Workers Scenario Tutorial provides you with a scenario-based approach to configuring of FreeSbc systems, using sample configuration files. Complete general installation configuration steps, before you begin configuring your specific application.

Prerequisites

FreeSbc devices must be installed as described in their respective installation guides.

Typical Remote Workers Sample without NAT

Typical Remote Workers Sample with NAT

Modifying configuration file

You can download sample configuration for Remote Office/Workers scenario from below;

Remote Office/Workers Sample Configuration without NAT
Remote Office/Workers Sample Configuration with NAT

• Open the json file with a text editor
• Replace following parameters in the file
  • WAN_00_IP and LAN_00_IP with IP addresses
  • WAN_00_Subnet and LAN_00_Subnet with IP subnets
  • WAN_00_Gateway and LAN_00_Gateway with Gateway IP addresses
  • Registrar_Domain_Name with Registrar Domain (IPPBX Domain)
  • All Registrar_IP with Registrar IP Address (IPPBX IP Address)
• If you downloaded Remote Office/Workers Sample Configuration with NAT file please change the following parameter too
  • Replace NAT_IP_Address with External IP
• Save the file

Uploading and activating the sample configuration

• You need to use an SFTP client to upload the configuration file to FreeSBC
• After upload the file use following commands from CLI
  • For Remote Office/Workers Sample Configuration without NAT

 tbconfig -u root -p root -C /configurations main_config.json name="main_config" -u root -p root
 tbconfig -U /systems/system_1/target_configuration="main_config"

• • For Remote Office/Workers Sample Configuration with NAT

 tbconfig -u root -p root -C /configurations main_config_nat.json name="main_config" -u root -p root
 tbconfig -U /systems/system_1/target_configuration="main_config"