Procedure for downgrade from rel2.6 to rel2.5
This page is the procedure to downgrade Toolpack v2.6 system to a Toolpack v2.5 system on a TMG3200 or a TMG800 unit.
Warning: Major downgrades require service interruption.
Configure a valid DNS
vi /etc/resolv.conf
nameserver 8.8.8.8 <- Should insert a valid DNS here
Download the proper v2.5 installer from TB site
1- Download installer from TB download site - http://download.telcobridges.com/
Contact TB support to get the complete link for the proper installer. ex. wget http://download.telcobridges.com/release2.5.142/TBToolPack-2.5.142-Linux-centos5-x86_64-Install --user xxxx --password yyyy
2- Change the permission of the installer
ex. chmod +x TBToolPack-2.5.142-Linux-centos5-x86_64-Install
Stop Toolpack Service
skip this step if it is TMG800 since toolpack will get restart after rebooting the host
tbtoolpack stop
Run Toolpack Installer (same as 2.4)
Copy the license
If not already done with the installation copy the license in the licenses directory
[InstallDirectory]/pkg/licenses/
ex.
/lib/tb/toolpack/pkg/licenses/
Modify the host role
vi /lib/tb/toolpack/setup/12358/2.5/toolpack.ini
...
TBX_GW_ADDRESS_0 = 172.31.1.2 TBX_GW_ADDRESS_1 = 172.31.1.2 TBX_PRIMARY_HOST = TRUE
...
Verify that the Toolpack service will start v2.5
Open the following file with vi.
vi /lib/tb/toolpack/setup/12358/service/config.txt
Make sure that the 'application=' line contain '2.5'.
application= /lib/tb/toolpack/setup/12358/2.5/apps/tboamapp/tboamapp_wd_cfg.ini
Copy vlan_management.rb file if using virtual IPs
Copy **vlan_management.rb** (if before 2.5.147) to this folder:
/lib/tb/toolpack/12358/2.5/apps/tboamapp/
Change boardmode (require for TMG800 only)
Warning: This step is important for TMG800 and it has to be done before start toolpack on rel2.5. For TMG3200, skip this step.
telnet 172.31.1.1 tml>debug2 CE-AA-CD-72 C8-A8-4E-BB Installing spr Done installing debug level 2 shell commands. tml>set_boardmode 1 *********************************************************** WARNING: Will restart the board to activate new board mode. *********************************************************** Continue? (y|n)=n? :y
Start Toolpack Service
skip this step if it is TMG800 since toolpack will get restart after rebooting the host
tbtoolpack start
Set tbuctwriter to “don’t run”
Webportal -> Applications -> Instances -> Status tab -> tbuctwriter -> Oam target state [Don't Run]
