Toolpack:Create a SCCP userpart

This step is used to initialize the userpart parameters of the SCCP layer

Description of parameters

General explanation of the configuration parameters:

• The Handle SCCP network parameter specifies the handle of the SCCP network
• The Unique identifier SCCP Userpart parameter specifies the unique ID of the SCCP Userpart for a SS7 system

---

• The Message priority parameter specifies the priority of messages. Allowable values are as follows:

SCCP Message Priority	Description
Highest
0	Same as highest
1
2
3	Same as lowest
Lowest

---

• The Connection mode parameter specifies the different modes of connection for a SCCP userpart. Allowable values include:

SCCP connection mode	Description
TCAP	SCCP userpart is used in conjunction with an above local TCAP layer and cannot be controlled by the host application but the host application will receive ALARM notifications
Host TCAP	SCCP userpart is used as a standalone and communicates with remote TCAP layer (host application)

---

• The Subsystem number parameter specifies a subsystem number for this userpart. Allowable values are from 1 to 255. See the table for '

SCCP SSN value to identify SCCP user' in Toolpack:Create a SCCP route.

• The Number backup point code parameter specifies the number of backup point code entries in the Backup Point Code Entries and the Priority Backup Point Code Entries arrays.
• The Array of backup point code entries parameter specifies the list of backup point code for this Userpart. This parameter is reconfigurable.
• The Array of priority of backup point code entries parameter specifies the list of priority of each backup point code for this Userpart. Allowable values are from 0 to 255.

Note: Zero being the lowest priority.

---

• The number concerned point code parameter specifies the number of concerned point code entries in the 'Concerned Point Code Entries' array
• The array of concerned point code entries parameter (specifies the list of concerned point code for this Userpart