Creating an M3UA Configuration (ASP)

Applies to version(s): v2.8

To set up your M3UA system as a Application Server Process (ASP), you must first create a new M3UA configuration.

In this configuration the the SIGTRAN M3UA is an extension of the MTP3 layer. This system is typically set up between Application Server Process (ASP) and Signaling Gateway Process (SGP).

To create an M3UA ASP configuration:

1- Click M3UA in the navigation panel:

2- Configure the M3UA service for ASP:

• Enter a name for the configuration
• Select Application Server Process (ASP) as the node type
• Click Create

3- Verify that the "M3ua Cfg was successfully created" message appears

List of Parameters

• Name
• Node Type

• Only one hardware unit is active
• Destination Restrict supported
• Congestion level 1
• Congestion level 2
• Congestion level 3
• Restart Timer
• MTP3 Status Timer
• AS Pending Timer
• Heartbeat Timer
• ASP Up Timer
• ASP Down Timer
• ASP Messages Timeout
• DAUD Timer
• DRKM Timer
• Number of DKRM messages
• DUNA Settle Timeout
• Sequence Control Timer