Toolpack v2.3:Configuring Your Tmedia System

This document assumes that the Tmedia or Tdev units are installed as described in their Quick Reference Guides and that communication has been established with the Tmedia control network. Furthermore, in the initial configuration of the Toolpack application server, the following will have been provided:

• The TMP6400 to which the Web Portal will first connect.
• The TMP6400 will have been pre-configured with its physical TDM interface.
• The serial number of the TMP6400 will have been entered into the configuration file.
• The application software for the TMP6400s will have been preinstalled on the Toolpack application server, as described in the TMP6400 Installation Guide.

Note: The TMG3200 is shipped with the Tmedia Web Portal preinstalled, while the TMP6400 requires that the Toolpack OAM&P be installed as described in the TMP6400 Installation Guide.

For further information about Tmedia or Tdev products, refer to the Tmedia System Architecture Description, 9020-00042-1A.

Order of tasks

The following list is presented here as a general guideline to suggest the order of tasks that are to be conducted to configure a Tmedia or Tdev system.

1. Log In
2. Start up the TMP6400 Toolpack applications
3. Add Tmedia units
4. Configure a TMS Network (TMP6400 systems only)
5. Add line interfaces
6. Create line services
7. Configure BITS ports
8. Configure system clocking
9. Configure the ISDN signaling
10. Configure SIP signaling
11. Configure SS7 signaling
12. Configure profiles
13. Configure NAPs
14. Configure a gateway application