FreeSBC:SIP Trunking:Configuration A
From TBwiki
(Difference between revisions)
m (Removed this line: *Create an IP port range (It was duplicated in two columns)) |
(→Prerequisites) |
||
| Line 6: | Line 6: | ||
==Prerequisites== | ==Prerequisites== | ||
| − | [[FreeSBC| | + | [[FreeSBC|FreeSBC]] devices must be installed as described in their respective [[Product_Installation_SBC|installation guides]]. |
== Typical SIP Trunking Sample == | == Typical SIP Trunking Sample == | ||
Revision as of 08:37, 15 March 2019
Applies to version: v3.0
Introduction
The SIP Trunking Configuration Tutorial provides you with a scenario-based approach to configuring and monitoring the status of FreeSbc systems, using the Web Portal configuration tool. Complete general installation configuration steps, before you begin configuring your specific application.
Prerequisites
FreeSBC devices must be installed as described in their respective installation guides.
Typical SIP Trunking Sample
SIP TRUNKING CONFIGURATION
| (Step 1) Create IP Network |
(Step 2) Create Protocol Stack |
(Step 3) Create Call Route |
|---|---|---|
Example Configuration
Step by step example SIP Trunk configuration.
Troubleshooting
| Call Trace (Paid version only) | Test Call (Paid version only) | TBReport | Advanced Troubleshooting of FreeSBC |
|---|---|---|---|
