FreeSBC:Asterisk
From TBwiki
(Difference between revisions)
| Line 52: | Line 52: | ||
[[Image:FreeSBC_Remote_Workers.jpg|800px| ]] | [[Image:FreeSBC_Remote_Workers.jpg|800px| ]] | ||
| + | |||
| + | ==Example Configuration== | ||
| + | |||
| + | Step by step example Remote workers configuration. | ||
| + | *[[FreeSBC:Remote Workers:Configuration_A|Remote Workers Configuration Instruction]] | ||
==Troubleshooting== | ==Troubleshooting== | ||
Revision as of 05:45, 5 August 2019
Contents |
Introduction
This Configuration Note describes how to set up Telcobridges FreeSBC/ProSBC for interworking between ITSP’s SIP Trunk or remote client access for Asterisk server.
NOTE: SIP Trunk use G.711 in this test. There is no transcoding available.
Prerequisites
- FreeSBC devices must be installed as described in their respective with release 3.0.x/3.1.x. Release 3.0.x is not supported for TCP connections installation guides.
- Asterisk.For additional information on Asterisk, visit [1]
Example Environments for SIPTrunking with Asterisk
FreeSBC/ProSBC Configuration for SIP Trunking with Asterisk
| (Step 1) Create IP Network |
(Step 2) Create Protocol Stack |
(Step 3) Create Call Route |
|---|---|---|
Example Configuration
Step by step example SIP Trunk configuration.
Example Environments for Remote Workers with Asterisk
Example Configuration
Step by step example Remote workers configuration.
Troubleshooting
| Call Trace (Paid version only) | Test Call (Paid version only) | TBReport | Advanced Troubleshooting of FreeSBC |
|---|---|---|---|
