FreeSBC:3CX SIP Trunk:Configuration A
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version: v3.1''''' === {{DISPLAYTITLE:SIP Trunk Configuration Instruction with 3CX}} =Introduction= SIP Trunk Configuration Instruction with 3CX Example ...") |
(→NAP Configuration) |
||
| Line 41: | Line 41: | ||
* See [[Toolpack:Allocating a SIP Network Access Point (NAP) SBC A|Create SIP NAP]] | * See [[Toolpack:Allocating a SIP Network Access Point (NAP) SBC A|Create SIP NAP]] | ||
| − | ** Here, You must create | + | ** Here, You must create two NAPs, one SIP NAP will be 3CX NAP and other NAP will be for SIP trunk provided by ITSP |
Revision as of 03:16, 10 March 2020
Contents |
Applies to version: v3.1
Introduction
SIP Trunk Configuration Instruction with 3CX Example Configuration provides you with a step by step SIP Trunk Configuration of FreeSbc with 3CX systems, using the Web Portal configuration tool. Complete general installation configuration steps, before you begin configuring your specific scenario. In this guide FQDN (telcobridges.3cx.ca) configured in the 3CX server. Please check how to configure the SIP Trunk in 3CX for ProSBC from Adding ProSBC as a SIP Trunk in 3CX Server
3CX SIP Trunk Example
Configuration Steps
| (Step 1) Create IP Network |
(Step 2) Create Protocol Stack |
(Step 3) Create Call Route |
|---|---|---|
|
NAP Configuration
- See Create SIP NAP
- Here, You must create two NAPs, one SIP NAP will be 3CX NAP and other NAP will be for SIP trunk provided by ITSP
