FreeSBC:Skype for Business TCP Only Configuration

Introduction

This Configuration Note describes how to set up Telcobridges ProSBC for interworking between ITSP’s SIP Trunk and Microsoft’s Skype for Business Server 2015 environment using TCP only.

In this introduction we used G.711 on SIP Trunk. There is no transcoding available. If your SIP trunk will use other codec then G.711, please check our transcoding solution. FreeSbc is capable to connect your IP-PBX to Skype for low cost VoIP calls using the Skype Connect. This is a simple how to connecting FreeSBC to Skype.

Prerequisites

• FreeSBC devices must be installed as described in their respective installation guides.
• Skype Connect Account

Typical Skype Connect Sample

SKYPE CONNECT CONFIGURATION

(Step 1) Create IP Network	(Step 2) Create Protocol Stack	(Step 3) Create Call Route
Configuring an IP Virtual Port Configuring a VLAN Configuring IP Interfaces Create an IP port range	Create an IP port range Create a SIP stack Create a SIP transport server Modify profile Allocate a SIP NAP Allocate an open SIP NAP	Create a first call route

Example Configuration

Step by step example Skype Connect with FreesBC configuration.

• Skype Connect Example Configuration

Troubleshooting

Call Trace (Paid version only)	Test Call (Paid version only)	TBReport	Advanced Troubleshooting of FreeSBC
Configure call trace Retrieve call trace	Creating a Test Call	Capture a report of the system	Advanced Troubleshooting of FreeSBC